Then at the meeting 4 lathes were set up ready to go. Members could then take a turn on a lathe and turn their blanks into handles for the awls. Jim and Steve were available as a mentor for anyone needing any guidance. I thought it was a great event.
Below (if this works) is a short video showing how it went off.
Give it a little time to load. You should be able to make the video screen larger by clicking the small box in the lower right corner of the viewer.
Edit:
Just before the movie viewer is a link to an online version of the movie. This will provide a little better quality video and it is the only way to see the video on an iPad.
Link to online version
